Preparing...Please wait...

New R3 version!

I revamped my design to perfectly fit the new R3 version of the Uno as well as maintain backwards compatibility! I also integrated slide guards in the box top as well as the plate for descrete access to control pins externally.

I've been pushing out multiple Arduino Uno builds and needed a secure plate and box combo that could keep assets safe during a fall and would allow for under plate wire runs. I ended up with a thick post base plate and box setup with an integrated Uno locking clip.

One picture shows my logo on the lid however the attached master file contains a solid lid.

Instructions are on my Instructables page: http://www.instructables.com/id/Arduino-Protection-Box/

Arduino on!

Loading Comments...

Go to Autodesk.com

For people who want to make things themselves, Autodesk 123D is free software integrated with content and fabrication services. Free products and services are subject to the Autodesk, Inc, terms of use that accompany them.

© 2014 Autodesk, Inc. All Rights Reserved.